Publicidad
Idiomas disponibles
Idiomas disponibles
2.3 Select room temperature
The desired room temperature for comfort and eco mode can be set in 0.5°C steps by turning the rotary knob (no additional con-
firmation needed).
Please note that the eco mode room temperature cannot be higher than the set comfort mode room temperature -1°C.
Selectable room temperature ranges
Comfort mode: 7-28°C (21°C default) | Eco mode: 7-19°C (16°C default) | Frost protection mode: 7°C (fixed)
The defined maximum surface temperature (which can be adjusted according to section 2.6) of the radiator is also taken into account
during room temperature regulation.
For regulating the room temperature, the eco or comfort mode can be used. The only difference between them is the temperature range.
2.4 Timer mode
In timer mode, the IHC heats at full power, considering the defined maximum surface temperature of the radiator. The room tem-
perature setting is not taken into account in this mode. The desired duration can be set by turning the rotary knob.
Selectable timer durations
The duration can be set in +/- 5min steps from 0min to 95min | The duration can be set in +/- 1h steps from 2h to 4h
The default timer duration is set to 60min
The default timer duration can also be changed in the settings of the Zehnder Connect-App.
Please refer to section 4.
English
2.5 Settings menu
To access the settings menu, press and hold the rotary knob for 3 seconds until „SEt" is displayed, then release.
"SET" is displayed for 2 seconds, after which the currently selected maximum surface temperature is displayed.
By briefly pressing the rotary knob, you can cycle through the different settings.
Pairing IHC
Select surface
temperature
with remote control (RCE)
The settings menu can be left by either pressing the rotary knob for 3s or by waiting for 10s without further interaction.
The settings menu can be left by either pressing the rotary knob for 3s or by waiting for 10s without further interaction.
All applied changes are applied and stored automatically.
All applied changes are applied and stored automatically.
Select surface temperature
Pairing IHC with remote control (RCE)
Pairing IHC with Connect Box
24
Pairing IHC
Select surface
with Connect Box
temperature
Publicidad
