Philips FC8130 Manual Del Usuario página 10

English
10
Note: Please visit www.s-bag.com for more information about the s-bag.
ordering filters and accessories
- HEPA exhaust filters are available under type number FC8070.
storage
1 Switch off and unplug the appliance.
2 Press the cord rewind button to rewind the cord (Fig. 29).
3 Put the appliance in upright position. To attach the nozzle to the appliance, insert the ridge on
the nozzle into the storage slot.
Note: To ensure stable storage of the telescopic tube, adjust the tube to the shortest length.
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 30).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at www.
philips.com or contact the Philips Consumer Care Centre in your country (you find its phone
number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country,
go to your local Philips dealer.
troubleshooting
1 The suction power is insufficient
- Perhaps the dustbag is full.
If necessary, empty the dustbag.
- Perhaps the filters need to be cleaned or replaced.
If necessary, clean or replace the filters.
- Perhaps the suction power slide on the handgrip is open.
Close the slide.
- Perhaps the electronic suction power control is set to a low setting.
Set the control to a higher setting.
- Perhaps the nozzle, tube or hose is blocked up. (Fig. 31)
To remove the obstruction, disconnect the blocked-up item and connect it (as far as possible) the
other way round. Switch on the vacuum cleaner to force the air through the blocked-up item in
opposite direction.