Publicidad
Idiomas disponibles
Idiomas disponibles
If the workplace is extremely hot, humid or with a high
concentration of dust, the socket circuit must be protected
with a circuit breaker (30 mA) to ensure the safety of the
user.
Do not expose the power tool to rain or operate it in wet or
damp conditions. The presence of water in a power tool
increases the risk of damage and electric shock to the user.
Never use the power cord to pull, carry or unplug the power
tool. Damaged power cords increase the risk of electric
shock.
Keep the power cord and plug away from heat sources, oil,
sharp objects and rotating accessories. Check the
condition of the power cord regularly, if it is damaged, it
must be replaced or repaired by a qualified technician.
Never change the power cord plug and use a socket which
is compatible with the plug. Do not use any kind of socket
adaptor.
The use of extension cords to plug in the power cord is not
recommended. However, if you use an extension cord, you
should take some precautions, such as:
▪ If you operate the power tool outdoors, use only
extension cords suitable for outdoor use. The use of a
suitable extension cord reduces the risk of electric
shock;
▪ Use only extension cords, plugs and sockets with earth
terminal;
▪ The cross-section of the extension cord's conductors
shall be proportional to the length and with the same
characteristics as or larger than the combined circular
saw's power cord;
▪ Do not use damaged extension cords. Examine the
extension cords before using them and replace if
necessary;
▪ Always unplug the extension cord before removing the
plug from the power tool;
▪ When using an extension cord reel, unroll the cord
completely.
Individuals who have not read the instruction manual and
are not familiarized with how to operate the combined
circular saw must not use it.
To ensure that you work with the power tool safely, you
should consider a few precautions and procedures before
start-up:
▪ Inspect the power tool before each use. Check that the
blade is installed correctly and is in good condition. In
case there is excessive damage or wear, replace it. Never
use blades that are damaged or deformed;
▪ Check that all bolts are properly tightened. Regular
inspection is important to ensure the safety issues and
good performances of the power tool;
▪ Check that the safety devices are in perfect condition
and function properly. Never use the power tool if the
safety devices are missing, inhibited, damaged or worn
out;
▪ If the ON/OFF switch is damaged or does not allow the
operation of the power tool to be controlled, it must be
repaired or replaced in order to
unintentional start;
▪ Remove any adjusting key or wrench before turning the
power tool on. A wrench or a key left attached to a
rotating part of the power tool may result in personal
injury;
▪ After the blade's installation and before using the power
tool, test it at full speed at no load for a while. Check for
misalignment of the blade or any other condition that
may affect the power tool's operation. Check that all
moving parts rotate smoothly, without abnormal noises;
▪ Make sure the blade rotates in the direction of the arrow,
which is shown on the blade.
Make all adjustments and work necessary for the correct
assembly of the power tool if you have any questions or
difficulties, contact your official dealer.
prevent any
Publicidad
