American Standard Aspirations TU06150 Serie Manual Del Propietário página 4

3
INSTALL VALVE TRIM (THIN WALL INSTALLATION)
Note: Plaster Guard will remain installed for thin wall installation.
• Figure 1. Remove SCREWS (7), push CAP (1) over VALVE CARTRIDGE (2) until seated against stop.
Note: Escutcheon Holder must be installed with number
facing out on bottom.
• Figure 2. Make sure O-RING (5) is secure within
ESCUTCHEON HOLDER (3). Push ESCUTCHEON
HOLDER (3) onto CAP (1) and attach with LONG
SCREWS (4).
• Figure 3. Install ESCUTCHEON (6) onto CAP (1)
and push flush against finished wall.
Escutcheon (6) will snap fit onto ESCUTCHEON
HOLDER (3).
B
4
INSTALL TUB SPOUT, SHOWER HEAD, SHOWER ARM WITH FLANGE
Protect finish to avoid scratching or damaging
the shower head and tub spout when installing.
• Remove pipe cap and plug from shower and
tubrough piping.
• Slide TUB SPOUT (1) on to the pipe and secure
with SET SCREW (5).
• Install SHOWER ESCUTCHEON (2) onto
SHOWER ARM (3). Apply sealant or Teflon tape
to threads on both ends of SHOWER ARM (3)
and thread longer leg of SHOWER ARM (3) into
shower elbow.
• Thread SHOWER HEAD (4) onto SHOWER
ARM (3).
CAUTION: Protect finish on SHOWER HEAD
and ARM when installing.
A C
2
3
5
4
Figure 2.
7
Figure 1.
3
1
2
Figure 3.
2
3
4
PIPE
CAP
1
2.5 MM HEX
WRENCH
2
1
6
SHR.
ELBOW
PIPE
PLUG
TUB FILLER
NIPPLE
E F .
" R
/ 1 6
3 - 1