elero Junior 1 Instrucciones De Montaje página 35

General
1 General
1.1 Information relating to the installation instructions
The classification of the contents is based on the life stages of the linear drive (here-
inafter referred to as the "device"). The manufacturer reserves the right to make
changes to the technical specifications stated in these installation instructions. In
detail these can differ from the respective version of the device without the factual
information being fundamentally changed and without losing their validity. The cur-
rent status of the technical specifications can be requested from the manufacturer at
any time. Any claims arising from this cannot be asserted. Deviations from the text
and pictorial statements are possible and are dependent on the technical develop-
ment, equipment and accessories of the device. The manufacturer shall provide
information about any differing details relating to special versions by means of the
sales documentation. Other specifications shall remain unaffected by this.
1.2 Standards and guidelines
During construction the fundamental health and safety requirements were ap-
plied and provision was made for the appropriate legislation, standards, direc-
tives and guidelines. The safety element is confirmed by the Declaration of
Incorporation (see section "Declaration of Incorporation"). All information relating
to safety in these installation instructions refers to the laws and regulations that
are currently valid in Germany. All information in these installation instructions
must be complied with at all times and without limitation. In addition to the safety
notices and directions in these installation instructions, the regulations applica-
ble at the place of installation with regard to accident prevention, environmental
protection and occupational safety must be observed and adhered to. The
guidelines and standards for safety assessment can be found in the Declaration
of Incorporation.
1.3 Intended use
The device is envisaged for use in the construction of machinery. It serves as a
means of adjusting small to medium loads. Other fields of application must be
agreed in advance with the manufacturer.
The device must not be used in areas where there is a risk of injury to personnel
or in rooms in potentially explosive environments.
3