Levolor Sheer Shadings Instalación página 14

CARE
Removing the Shading
• Fully raise the shading.
• Move the lever on the installation brackets to the left
to release the shading.
— A flat head screwdriver can be
used to move the lever.
— If the lever is inaccessible or
inoperable, lower the shading
until you can see the underside
of the bracket. Carefully reach
a small flat head screwdriver
behind the shading to the
tab on bottom of the bracket
between the screw holes.
— Push the tab away from the
shading and pull the headrail
to release it from the bracket.
CAUTION: Be very careful to not tear or damage any of the fabric.
• Carefully pull the shading to remove it from the brackets.
Cleaning Procedures
Sheer shadings are made of 100% polyester, which means they are inherently durable
and resilient. However, care must be taken to avoid wrinkling the fabric, particularly
where the vanes meet the facings.
Dusting
• Regular light dusting with a feather duster is all the
cleaning that is needed in most circumstances.
Vacuuming
• Use a low suction, hand-held vacuum for more
thorough dust removal.
Forced Air
• Blow away dirt and debris between the vanes using
clean compressed air.
Spot-Cleaning
• Do NOT spot-clean sheer shadings.
14
Sheer Shadings Motorized Operating System
Top View
Installation Bracket
Tab
Underside of
Bracket
Move Lever to Left
End Cap
Facing
Vanes