Levolor Sheer Shadings Instalación página 7

— Mark location for the screws within the slots in the
bracket. The bracket location can be adjusted back or
forth based on the casement depth.
IMPORTANT: The front edges of the installation brackets
must be level and aligned to each other.
CAUTION: Failure to properly align the brackets could result in the
!
headrail releasing from the brackets causing the shading to fall, possibly
resulting in injury or property damage.
• Drill the screw holes using a
IMPORTANT: Use drywall anchors when mounting
• Use a level to check that the mounting surface is level.
Shim the brackets, if necessary.
• Attach the installation brackets using the screws provided.
IMPORTANT: Do not overtighten the screws. Check to ensure the lever can be
moved easily side to side. If not, loosen the screws in one-eighth turn increments
until the lever can be moved easily.
• If using spacer block(s), stack spacer block(s) on
top of the installation brackets. Using #6 Hex Head
Screws, long enough for secure installation (not
provided), install screws up through the underside
of the installation bracket and spacer block(s) into
mounting surface.
IMPORTANT: Do NOT add more than 1 ½". of clearance using the spacer blocks.
OUTSIDE MOUNT
Mount the Installation Brackets
• Center the headrail over the window opening at the desired height. Use a pencil to
lightly mark each end of the headrail.
— Alternatively, measure the width of the headrail and use that width to mark the
headrail end points over the window opening.
• Mark 5" from each end of the headrail.
— If more than two installation brackets came with your order, space additional
bracket(s) evenly between the two end brackets and mark their location.
Mount into wood whenever possible.
/ " drill bit.
3
32
into drywall.
Sheer Shadings Motorized Operating System
INSTALLATION
Mounting
Depth
Lever
Spacer
Blocks 1½"
Maximum
7