the installation.
Before installing the product, remove the unnecessary cord and disable any equipment not needed
for power operation.
Choosing a safe location
Never install it in high and windy places, as the sunshade may drop and hurt people. The location
for mounting your automation device: this location must allow for the automation device to pick up
the signals easily to ensure maximum sensitivity of the command box.
Do not use it in places that have vibrations or impulsions.
In case of use of a command box, the electronics board must be set vertically and sheltered from
the weather.
The installation can be made by non-professionals assuming the instruction is followed correctly.
Should you have any trouble during assembly, please consult a qualified person for help.
Please use all the screws and nuts correctly during installation as it is very dangerous if you leave
it loose.
Be careful with your fingers around moving parts of the product during installation.
3. ELECTRICAL SAFETY
CAUTION: The installation must be conform to the regulation of the country.For your safety, please
operation.
> Waterproof junction box (P54)
> Cables
Before connecting the appliance to the power supply, check that the power supply voltage and
current rating corresponds with the power supply details shown on the appliance rating label.
A readily accessible disconnect device must be incorporated in the fixed wiring in compliance with
setup regulations.
Danger of electric shock! Do not attempt to repair the appliance yourself. In case of malfunction,
repairs are to be conducted by qualified personnel only.
The modification of the design or configuration of the equipment without consulting the
manufacturer or his authorized representative may create a dangerous situation.
The power cable for this motor can only be replaced with the same type of cable supplied by the
motor manufacturer.
What you will need: hardware not provided:
BATTERIES
>
(CR2430 3V)x 1
87
FR
ES
PT
I T
EL
PL
UA
RO
NL
EN