Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
a. Assembly of the chain guide
IMPORTANT: The machine must not be started during assembly. Wear protective
gloves when handling the blade.
Your chain saw is supplied one SDS system for assemble and adjust quickly for chain
tension. The outside ring (part 1) adjusts the tension of the chain and the inner screw
adjusts the tension of the bar. Turn the inner screw (part 2) of the SDS counter-clockwise
to open the chain over. (See Fig.3)
1) Unpack all parts carefully.
2) . Place the chain saw on any suitable flat surface.
3) . Spread the saw chain out with the cutting edges (A) of the chain pointing in the direction
of rotating. Slide the saw chain into the slot around the chain bar. Ensure chain is in correct
running direction.
(See Fig.4a, 4b)
4)
. Fit the chain bar onto the drive sprocket (11) and fastening bolt, and assemble safety
guard. (See Fig. 5)
Fig.5
5) The chain is not yet tensioned now. Tensioning the chain applies as described under
"Tensioning chain". After running the chain saw around 1 hour, adjust the chain tension to
2mm by applying 9N of torque
2.
OPERATION
Before using the chainsaw, inspect the work area. This must be cleared. Remove any
branches, obstacles and other items that may cause damage during cutting.
Publicidad
