Publicidad
Idiomas disponibles
Idiomas disponibles
d.
Release of a jammed saw
If the saw gets stuck during cutting, the operators should:
Saw the saw and attach it securely to the cutting foot of the shaft (i.e., trunk side) or has
-
a separate chord from the tool
Pull the saw of the cluster while the branch is lifted, if necessary,
-
•
If necessary, use a hand saw or a second chainsaw to release the chain saw.
4. Cutting work
The tool should only be used to cut trees. Do not use it for other applications.
Do not attempt to remove the chainsaw when it is stuck during operation. Stop the machine
and remove the wedge blade with a wedge.
Stick your feet well, keep a good balance and do not climb on the tree trunk.
Try not to work on a slope. However, if you have to work on a slope, always stand higher
than the tree trunk.
Before bending a branch or trunk in bending, observe the direction of bending and finish the
cut opposite the bending side to prevent the chain guide from getting stuck in the cut.
a .Felling of the trees
Examine the work area and estimate where the tree will fall. Start the machine as described
above. Start by making a notch in the direction of fall chosen.
When the tree falls, shout or make a beep to alert people in the vicinity. When the shaft
falls, move away from the cutting area.
Publicidad
