Publicidad
Idiomas disponibles
Idiomas disponibles
5. MAINTENANCE AND STORAGE
2. Maintenance
Before any maintenance work, the machine must be switched off and completely cooled.
Perform the maintenance work according to the instructions below and perform them
regularly. A clean, well- maintained machine increases its standard of living and efficiency.
On the contrary, a machine maintained can cause damage, accidents and render the tool
inoperable in the short term.
Any other maintenance, modification or repair work must be carried out by a qualified
professional.
Do not immerse the tool in water or any other liquid.
After each use
a.
Keep saw body clean, use a soft cloth dampened with a mild soap and water mixture, wipe
saw body to clean.
Guide bar
b.
Cleaning: Remove bar guide to remove dirt from grooves and oil inlet. Regularly grease the
pinion.
Check: Reverse the bar from time to time to avoid the effects of wear. The bar rail should
always be in place. Use a ruler to observe it. If a gap is observed between them, then the rail
is normal. Otherwise, the rail is worn out. A bar must be corrected or replaced.
Publicidad
