Casals CSC1205B Instrucciones De Uso página 9

battery charged at least at 40%.
HOW TO CHECK THE BATTERY'S
CHARGE LEVEL WHEN CHARGING
LED light from the charger will become green
when the battery is fully charged.
ASSEMBLING THE BATTERY/S
Insert the battery to the hole at the bottom of
the appliance. Until it's fully mounted.
Press until you hear a click.
INSTRUCTIONS FOR USE
INSERT A DRILL/SCREWDRIVING BIT:
To open the drill's chuck, whilst completely
switched off, take firm hold of the back part of
the chuck and turn the front part of the chuck
counter clockwise.
Insert the drill bit or the screwdriver bit required
for the task, into the chuck. In order to obtain a
secure fastening of the bit, insert the bit as far
as you can into the chuck. Take firm hold of the
back part of the chuck and turn the front part of
the chuck clockwise until it is firmly closed.
In order to remove accessories from the chuck,
follow the same steps as indicated previously
but in reverse order.
BEFORE USE:
Ensure that every part of the packaging has
been removed.
Ensure that battery is charged and mount it
according to the instructions.
Select the direction you want to use using the
Forward / Reverse Selector (E).
Select the torque needed if you are
screwdriving using the torque adjustment ring
(B).
Insert the accessory you need according to
previous instructions.
USE:
Turn the appliance on, by using the on/off
switch.
LED light (H) will assist you on your view and
power indicator lights will lighten up showing
the actual level of the battery.
Perform the operation needed by pressing onto
the surface you desire to drill or screwdriving
the screws needed.
ELECTRONIC SPEED CONTROL:
The speed of the appliance can be regulated
by releasing or applying pressure on the On/Off
switch. This function is very useful, as it makes
it possible to adapt the speed of the appliance
to the type of work that needs to be done.
DRILLING, DRIVING
Drilling (wood, steel ...):
Turn the function selector ring until points to (
).
To drill, ALWAYS have the direction set to
clockwise (CW).
Screwdriving
Set the torque setting in order to adjust the
power to be applies in the screws.
To screw, ALWAYS have the direction set to
clockwise (CW).
To unscrew, set the direction to counter
clockwise (CCW).
The appliance should not be in use when
changing the screwing direction.