Aprimatic ROLL 500S Instrucciones Para La Instalación página 10

LAYOUT
1 2 3 4 5
IMPORTANT
The equipment must be secured to a switch (including a thermal-magnetic circuit
breaker if necessary) that ensures the omnipolar disconnection of the mains,
compliant with installation rules .
TECHNICAL SPECIFICATIONS
Power supply
Engine power
Running time
Closing time programmable
Combination codes
Memory capacity
Programming codes
Setting functions
Frequency
Homologations
Sensitivity
Scope
Antenna
Operating temperature
6 7 8 9 10 11
230V ac / 50Hz +- 10%
1 HP ( 1350 W )
2 minutes 30 seconds
programmable 3 minutes
72 million codes
up to 25 codes
self-teaching
stores the function code
433.92 Mhz
2014/35/UE, 2014/30/UE,2014/53/EU
Greater than -100 dBm
standard 50 m-dead man 10 m.
Built-in
de -10ºC a 55ºC
PG9
PG9
**
ATTENTION: Check always if the power
absorbed of the rolling shutter motor is
supported by the Roll500S control unit. If
it is not supported, please, always connect
an power relay as auxiliary.
**
10
Wall fixing by 4
anchors.
For connection, use
cable type H07RN-F
PG7
2x1.5mm² four cable
gland PG9 (Power
supply+
motor) and
PG7
multipolar cable for
PG7 (accessories).