Aprimatic ROLL 500S Instrucciones Para La Instalación página 13

MANUAL STORING
a)To store the code, press the programming button PROG/RES until the buzzer
is activated (1beep). The red LED turns on and when the button is released the
LED remains on indicating that the device is ready to save the transmitter code
From this moment on, any code that will be received will be stored (if the code
is a Rolling-Aprimatic code, only transmitters with APRIMATIC code will be
accepted; in case of HCS code, both transmitters with HCS and APRIMATIC
code will be accepted).
Then press the transmitter function to be used to activate the automatism. The red
LED, accompanied by the buzzer (3beeps), will start flashing to confirm that the
storing has been performed (if 2 beeps are emitted when pressing, it means that the
TX is not compatible with the control unit and the system exits the learning mode).
After 4 seconds from the last time a code was received, the device automatically
exits the storing mode, turning the red LED off and emitting two short beeps.
For control unit learning in the version with 3 buttons, press STOP (button B of the
remote control).
buzzer is enabled (2 beeps). From this moment on, any code received with the
same function used to save the transmitter used with the special function will be
stored.
The storing will be confirmed by the red LED flashing and by a short beep; the
panel will automatically exit the storing mode, turning the red LED off and emitting
two short beeps.
CANCELLATION OF ALL CODES
All codes can be cancelled by resetting the memory. Press the PROG/RES button
for 4 seconds. A rapid sequence of red flashing lights and a short beep will be
emitted, indicating that all the codes previously stored have been cancelled.
FULL MEMORY INDICATION
When attempting to save new codes when the memory is full and after 27 different
codes have been stored, the red LED starts to flash and a sequence of beeps is
emitted for 5 seconds.
STORING VIA RADIO TRANSMITTER
In order to use this system, at least one
transmitter must previously have been
stored through the system a). Set DIP3 to
ON.
Press together the buttons A-B-C of one of
the transmitters previously stored in order
for the device to receive new remote
controls; the red LED turns on and the
13