Publicidad
Idiomas disponibles
Idiomas disponibles
Step
Ladder
SHUT OFF POWER AT THE CIRCUIT BREAKER OR FUSE
PANEL BEFORE REMOVING THE OLD FIXTURE OR
READ ENTIRE INSTALLATION PROCEDURE BEFORE YOU BEGIN!
LIGHT FIXTURE REQUIRES A 120VAC
ELECTRICAL SYSTEM.
LIGHT MUST BE PROPERLY GROUNDED.
SOME REGIONAL/LOCAL CODES REQUIRE
INSTALLATION BY A QUALIFIED
ELECTRICIAN.
WARNING!
This fixture can only be installed over a recessed
electrical box OR a UL-Listed surface mount electrical box
rated for wet locations. Surface mount electrical boxes
require the use of the included foam gasket, to prevent
water from seeping into the electrical box.
WARNING!
BURN HAZARD: Keep fixture's lamp heads at
least 2 in. from combustible material.
CAUTION!
BURN HAZARD: Allow light to cool down
prior to touching.
WARNING!
To avoid water damage, position light heads and
sensor head in the correct position as indicated.
FCC STATEMENT:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not
expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures: 1) Reorient or relocate the receiving antenna. 2) Increase the
separation between the equipment and receiver. 3) Connect the equipment into an outlet on a circuit different from that of the receiver. 4) Consult the dealer or an
experienced radio/TV technician for help. FCC responsible party name : Good Earth Lighting Inc. Address: 1400 E Business Center Drive, STE 108 Mount
Prospect, IL 60056 USA. Telephone number: 1-800-291-8838
Need Help?
Tools Needed
Phillips Head
Screwdriver
Safety Information
INSTALLING THE NEW ONE.
Please visit our website at: https://goodearthlighting.com/contact-us or call the
Customer Care Center 1-800-291-8838, 8:30 a.m.-5 p.m., CST, Monday-Friday.
Work
Gloves
WARNING!
Do not look directly at the LEDs for an extended period
of time. They can cause eye damage.
CAUTION
Minimum 90°C supply conductors. For fixture electrical
ratings, see fixture label.
CAUTION
Please consult a qualified electrician if you are
unfamiliar with electrical installations, or methods of
properly grounding an electrical fixture.
CAUTION
Fixture will reliably operate between the temperatures
of -20°F to 122°F. (At temperatures above 92°F, the PIR may
not detect body heat.)
WARNING!
The components of this fixture are not serviceable.
Attempting to alter the fixture for any reason may result in
voiding the warranty and could result in creating a dangerous
situation.
ATTENTION
LEDs can be damaged by electrostatic discharge shock.
To remove this hazard, touch a grounded bare metal surface
to discharge yourself before installation.
Safety Glasses
3
Publicidad
