Publicidad
Idiomas disponibles
Idiomas disponibles
The fixture has a built-in light sensor that prevents the motion sensor or area light from
activating during daylight hours. Once the power has been turned on, the fixture needs
around 20 t0 30 seconds to warm up. The light will turn o after around 20 seconds, then the
light will go to the SetToGo factory presets (50ft. detection range, 3 minute light activation.)
Set to
ATTENTION!
This fixture includes a TEST mode for customizing the settings. Switch the TIMER control knob
to TEST. TEST allows the light to activate in daylight hours to change the Set to Go settings.
1
IMPORTANT
8
How the Controls Work
FACTORY PRESETS
Set-to-Go: The security light is PRESET at the factory with
the following settings:
Range: 50 feet
Minutes: 3 min.
(duration)
If these settings are acceptable for your needs, you
don't need to do anything more with the SetToGo settings
except to do the actual electrical installation of the fixture.
To change the factory SetToGo default settings, follow the
instructions below.
Customize Settings
SECURITY LIGHT TIME SETTINGS
To change the duration the light remains on after detecting motion,
rotate the "Minutes" dial to the preferred setting:
Test: ONLY use during initial set-up. "Test" allows the
motion detector to work during daylight hours to
fine-tune the PIR sensitivity.
1':
Light will stay on for 1 minute after PIR detects motion.
2':
Light will stay on for 2 minutes after PIR detects motion.
5':
Light will stay on for 5 minutes after PIR detects motion.
10':
Light will stay on for 10 minutes after PIR detects motion.
THE DIAL MUST BE ROTATED AWAY FROM THE TEST SETTING FOR THE
LIGHT ACTIVATION TO WORK PROPERLY. ROTATE THE DIAL TO A POINT
ANYWHERE BETWEEN THE 1' AND 10' SETTINGS AND THE LIGHT WILL ONLY
ACTIVATE DURING NIGHTTIME HOURS.
Detection distance
to MAX.
Time the light stays on after
detecting motion
Light
Activation:
3 min.
Publicidad
