2
VERIFYING RANGE SETTING
To confirm the set distance, perform a "walk by test." Walk straight across the
sensor field at the approximate distance set on the RANGE control knob.
IF THE TEST FAILS, try adjusting the sensor head toward the detection zone.
Sensor head can be adjusted either up, down, left, or right.
IMPORTANT
IF THE POWER GOES OUT, THE FIXTURE WILL MAINTAIN PREVIOUS SETTINGS, SO
THERE IS NO NEED TO GO UP THE LADDER TO ADJUST.
If fixture has had continuous power, to switch to manual mode follow below steps.
STEP 1
ON
ON
OFF
OFF
2 Seconds
If power has been interrupted, must turn on to warm it up for 20 - 30 seconds.
STEP 1
Turn on for
20-30 secs.
ON
to warm up
sensor
OFF
IMPORTANT
LIGHT IS DETECTED, IT WILL ALLOW THE MOTION SENSOR TO RETURN TO CONTROLLING THE FIXTURE
THE NEXT DAY.
IMPORTANT
ACTIVATE REGARDLESS OF TIME OF DAY. HOWEVER, THIS PROCESS MUST BE RESET EACH DAY AFTER
DUSK TO DAWN FEATURE CYCLES THE PREVIOUS DAY'S MANUAL OVERRIDE CYCLE OFF.
Customize Settings (cont.)
SECURITY LIGHT SENSOR RANGE SETTINGS
To change the sensitivity of the PIR distance sensing, rotate the
"Range" dial the preferred setting:
10Ft: 10 feet, short range
20Ft: 20 feet, average range
50Ft: 50 feet, long range
Max.: Up to 70 feet, extra long range
Rotate the RANGE control knob to any of the marked presets: 10 Ft. to Max. (~ _ 70 ft.).
When the RANGE control knob is turned to 10 Ft., the detection zone is very tight and
compact, causing the detection sensitivity to be very high. When the RANGE control knob
is turned to Max., the detection zone becomes very broad, resulting in a low sensitivity.
Manual Override
POWER OUTAGE
Switch the
power OFF
and then
ON within
2 secs.
STEP 2
ON
OFF
2 Seconds
THE SECURITY LIGHT WILL REMAIN ON UNTIL THE INTERNAL
DUSK-TO-DAWN SENSOR DETECTS THE NEXT DUSK-DAWN CYCLE. ONCE
MANUAL OVERRIDE ALLOWS THE LIGHT TO TURN ON AT ANY TIME, BY
OVERRIDING ALL SENSOR CONTROLS. IT ENABLES THE LIGHT TO
to MAX.
Switch the
power OFF
ON
and then
ON within
OFF
2 secs.
Walk by Test
9