Publicidad
3
•
CARE
3.1 RECOMMENDATION FOR THE
GOOD USE OF VITROCERAMİC
* Use pots or pans with thick, completely
flat bottoms.
* Pans with a smaller diameter than the
shown
heating
recommended.
* Do not slide pots and pans over the
glass as they may scratch it.
* Although the glass can withstand
knocks from large pots and pans without
sharp edges, try not to knock it.
* To prevent damage to the ceramic
glass induction surface, try not to slide
the pots and pans over the glass, and
keep the bottoms of the vessels clean
and in good condition.
Try not to spill sugar or products
containing sugar on the glass while the
surface is hot as these could damage it.
3.2 CLEANING AND MAINTENANCE
To keep the appliance in good condition,
clean it using suitable products and
implements once it has cooled down.
This will make the job easier and avoid
the build-up of dirt Never use harsh
cleaning products or tools that could
scratch the surface, or steam-operated
equipment.
Light dirt not stuck to the surface can be
cleaned using a damp cloth and a gentle
detergent
or
warm
However, for deeper stains or grease use
a special cleaner for ceramic hot plates
and follow the instructions on the bottle.
Dirt that is firmly stuck due to being
burned repeatedly can be removed using
a scraper with a blade. Slight tinges of
colour are caused by pots and pans with
dry grease residue underneath or due to
area
are
not
soapy
water.
30
grease between the glass and the pot
during cooking.
These can be removed using a nickel
scourer with water or a special cleaner
for ceramic hot plates. Plastic objects,
sugar or food containing a lot of sugar
that have melted onto the surface must
be
removed
immediately
scraper.
Metallic sheens are caused by dragging
metal pots and pans over the glass.
They can be removed by cleaning
thoroughly using a special cleaner for
ceramic glass hot plates, although you
may need to repeat the cleaning process
several times.
Warning:
Use the glass scraper carefully. The
blade could cause injury!
If you use the scraper incorrectly, the
blade could break and a fragment could
get caught between the surrounding trim
and the glass. If this happens, do not try
to remove it using your hands, carefully
use tweezers or a knife with a fine edge.
(See fig. 3)
using
a
fig. 3
Publicidad
