Publicidad
Step 5
å
Separate two LONG EXTENSION SLIDES (2) from the LONG EXTENSION RAILS (1) as shown in the
upper diagram below. Be prepared, the parts are greasy.
å
Fasten two LONG EXTENSION RAILS (1) to the lower EXTENSION BLOCKS (F). Use four 1/2" FLAT
HEAD SCREWS (23) through the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
Then, slide the inner cartridge of the EXTENSION RAIL in to find the other hole that lines up with the
hole in the EXTENSION BLOCK. Turn a SCREW into this hole.
å
NOTE: The LONG EXTENSION SLIDES will be used later for the LARGE DRAWERS.
1/2" FLAT HEAD SCREW
1
st
427854
23
(4 used in this step)
1
Push the black lever and pull the SLIDE from the RAIL.
1
st
1
H
F
www.sauder.com/service
hole shown in the enlarged diagram.
st
2
The post
must be here.
J
7
Open end
1
st
1
F
Page 11
Publicidad
