Publicidad
Step 16
å
Separate two LONG EXTENSION SLIDES (2) from the LONG EXTENSION RAILS (1) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten two LONG EXTENSION RAILS (1) and two NARROW EXTENSION BLOCKS (O) to the UPRIGHTS (K and L).
Use four 9/16" FLAT HEAD SCREWS (20) through the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the UPRIGHT and EXTENSION
BLOCK. Turn a SCREW into this hole.
å
NOTE: The LONG EXTENSION SLIDES will be used later for the LARGE DRAWERS.
Open end
This hole is closer
to this edge.
Page 22
9/16" FLAT HEAD SCREW
(4 used in this step)
1
1
st
Push the black lever and pull the SLIDE from the RAIL.
1
st
1
L
O
www.sauder.com/service
hole shown in the enlarged diagram. Then, slide the inner
st
20
K
7
2
Open end
1
st
1
O
This hole is closer
to this edge.
427854
Publicidad
