Publicidad
Step 15
å
Carefully flip the UPRIGHTS (K and L) over.
å
Separate two SHORT EXTENSION SLIDES (4) from the SHORT EXTENSION RAILS (3) as shown in the upper
diagram below. Be prepared, the parts are greasy.
å
Fasten two SHORT EXTENSION RAILS (3) and two NARROW EXTENSION BLOCKS (O) to the UPRIGHTS (K and L).
Use four 9/16" FLAT HEAD SCREWS (20) through the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the UPRIGHT and EXTENSION
BLOCK. Turn a SCREW into this hole.
å
NOTE: The SHORT EXTENSION SLIDES will be used later for the SMALL DRAWERS.
1
Open end
This hole is closer
to this edge.
427854
9/16" FLAT HEAD SCREW
(4 used in this step)
3
st
Push the black lever and pull the SLIDE from the RAIL.
1
st
3
O
L
www.sauder.com/service
hole shown in the enlarged diagram. Then, slide the inner
st
20
The post
must be here.
1
st
K
4
Open end
3
This hole is closer
to this edge.
O
7
Page 21
Publicidad
