Publicidad
Step 22
å
Separate two SHORT EXTENSION SLIDES (4) from the SHORT EXTENSION RAILS (3) as shown in the
upper diagram below. Be prepared, the parts are greasy.
å
Fasten two SHORT EXTENSION RAILS (3) to the EXTENSION BLOCKS (F). Use four 1/2" FLAT HEAD
SCREWS (23) through the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
slide the inner cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the
EXTENSION BLOCK. Turn a SCREW into this hole.
å
NOTE: The SHORT EXTENSION SLIDES will be used later for the PENCIL DRAWER.
Use these holes.
3
1
st
Push the black lever and pull the SLIDE from the RAIL.
1/2" FLAT HEAD SCREW
(4 used in this step)
1
st
Open end
3
F
Page 28
23
www.sauder.com/service
hole shown in the enlarged diagram. Then,
st
4
1
st
3
F
7
Open end
427854
Publicidad
