Publicidad
Idiomas disponibles
Idiomas disponibles
2
INSTALLATION AND OPERATION MANUAL
2. INSTALLATION WORK
2.1. SELECTION OF INSTALLATION PLACE
Select a suitable place for handling and determine the installation place of the
controller with customer' s acceptance.
2.2. BEFORE INSTALLATION
Check the contents and the number of the accessories in the packing.
2.3. INSTALLATION PROCEDURE
1. Insert edge of a flat head screwdriver into the dent part at the bottom of the
holding bracket, push and turn the screwdriver and remove the controller
from the holding bracket as shown in the next figure.
Controller
Holding
Dent
Bracket
Part
Screwdriver
the Control unit
with cable, for
Operation control
Bottom view
Dent part
Dent
Screwdriver Holding
part
2 screws M4 x 16L
For fixing the Holding
Bracket onto the wall
Bracket
Holding
Bracket
Dent part
Publicidad
