Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENTS
WARNING
: Before it is put into ser-
vice, the system must be tested to check the
operating conditions of every single compo-
nent and identify any malfunctions. In this
stage, it is important to check that all health
and safety requirements have been com-
plied with in full.
To test the system, make the following checks.
INSTRUCTIONS AND WARNINGS FOR ADJUSTMENTS
The appliance's main functions do not requi-
re any special adjustments by specialist staff
except the settings made during use by the
user.
INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS
The appliance does not require the replace-
ment of operating components by specialist
staff except the replacement of standard parts
which can be carried out by the user.
EQUIPMENT DECOMMISSIONING, DEMOLITION AND DISPOSAL
NOTE
: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during decom-
missioning.
When decommissioning the appliance, a series
of procedures must be carried out to ensure that
the appliance and its components are not a hin-
drance and are not easily accessible.
To ensure that the appliance cannot constitute
hazards for people or the environment, all ener-
gy sources (electricity, etc.) must be disconnect-
ed and rendered unusable, and any liquids pre-
sent must be drained (lubricants, fl uids, etc.).
3320021_inst_GB
TESTING OF THE APPLIANCE
ADJUSTMENTS
REPLACING PARTS
Check that the mains voltage is the same as
)
that of the appliance.
Turn on the master switch to check the elec-
)
trical connection.
Check that the safety device is operating cor-
)
rectly.
After testing, if necessary instruct the user in all
the skills necessary for putting the appliance
into operation in conditions of safety, in ac-
cordance with legal requirements.
Place the appliance in a suitable area which is
not easily accessible, with barriers to prevent an-
yone from accessing it.
When scrapping, sort all components by chemi-
cal characteristics and dispose of them separate-
ly in accordance with the relevant legal require-
ments.
IMPORTANT: Do not dump non-bi-
odegradable products, lubricating oils, and
non-metallic components (rubber, PVC, res-
ins, etc.) in the environment. Dispose of
them in compliance with the relevant laws.
ENGLISH
11
Publicidad
