Angelo Po 0N0PE4 Manual De Uso página 26

ENGLISH
Although the appliance is complete with all sa-
fety devices, during installation and connection
additional devices must be added if necessary
to comply with the relevant legal requirements.
Safety thermostat with automatic reset:
A)
to warn of overheating in the components
compartment.
– Red light on: no power supply to the plates.
– Red light off : power supply to the plates.
The illustration shows the position of the signs
provided.
Nameplate with
A)
appliance data.
WARNING: read the manual careful-
B)
ly before carrying out any procedure.
WARNING: When washing the ap-
C)
pliance do not point pressurised water jets at
internal parts.
WARNING: all relevant regulations
D)
must be complied with. "Install in complian-
ce with the relevant regulations and use in
well ventilated premises only".
WARNING: all relevant regulations
E)
must be complied with. "No liability is ac-
cepted in case of failure to comply with the
installation and commissioning instructions".
WARNING: watch out for hot surfa-
F)
ces.
4
SAFETY DEVICES
SAFETY AND INFORMATION SIGNS
manufacturer and
IMPORTANTE: If the safety ther-
mostat trips too frequently, contact the
Assistance service.
E
D
F
37M3202
C B
CE marking: this indicates that the
G)
equipment is compliant with all relevant laws
applicable to the product.
WEEE symbol: indicates that the appliance
H)
is subject to specifi c waste disposal regula-
tions.
SAFETY
G
A
H
3320021_ut_GB