GreenWorks GD48GTE33 Manual Del Operario página 9

6.3 REPLACE THE SPOOL
Figure 15 - 17.
1. Simultaneously press the tabs on the sides of the
trimmer head.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot
on the new spool, and is extended approximately 13
cm. before you install the new spool.
5. Put the end of the cutting line through the eyelet.
6. Extend the cutting line to release it from the guide
slot in the spool.
7. Push the tabs and install the spool cover onto the
spool housing.
8. Push the spool cover until it clicks into position.
6.4 REPLACE THE CUTTING LINE
Figure 18 - 20.
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 2.0 mm
diameter.
1. Cut a piece of cutting line approximately 3 m
long.
2. Bend one end of the line approx. 6 mm.
3. Insert the line into the anchor hole of the spool.
4. Wind the cutting line around the spool tightly in
the indicated direction.
IMPORTANT
Failure to wind the line in the indicated direction will
cause the trimmer head to operate incorrectly.
5. Put the cutting line in the line slot.
6. Do not wind the cutting line beyond the edge of
the spool.
7 TRANSPORTATION AND STORAGE
WARNING
Remove the battery pack from the machine before
transportation and storage.
English
NOTE
NOTE
NOTE
7.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack.
• Assemble the blade guard.
7.2 STORE THE MACHINE
• Remove the battery pack from the machine and
charge it.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
7
EN