Publicidad
Idiomas disponibles
Idiomas disponibles
Eltego
| Electric Wheelchair
3.5.4. Suspension
You can adjust the suspension to your weight for a comfortable drive.
•
You will need a special wrench to adjust the spring deflection.
(Please contact the service department)
•
Pushing the spring together results in a reduced spring deflection
and a "harder" setting.
7
•
Expanding the spring increases the spring deflection and
guarantees a "softer" setting (Fig. 7).
3.5.5. Armrests
The armrests can be completely taken off to be able to get in and out
of the chair from the side. In addition, the height of the armrests can
be adjusted. They can also be adjusted sideways by adjusting the side
parts (see side parts) (Fig. 8)
8
Removing the armrests
•
To remove the armrest, loosen the wing bolt and pull out the
armrest to the top.
•
When installing the armrest, make sure it is inserted all the way
and fastened again.
Adjusting the height
•
First take the armrest out of the mounting.
•
Remove the arresting bolt and screw it back into the armrest at the
desired position.
•
The lowest hole represents the maximum height of the armrest.
58
Make sure that both suspensions on the right and
left are adjusted the same.
3.5.6. Side Parts
You can slide the side parts sideways.
•
Loosen the fastening (SW 13) below the seat and slide the side part
into the desired position.
•
Tighten the fastening again (Fig. 9).
Make sure the fastening is firmly tightened.
3.5.7. Control Unit
The control unit can be mounted either on the right or left-hand side
underneath the armrest each (Fig. 10).
•
The control unit must be adjusted by a qualified mobility dealer to
warrant safe functionality of the wheelchair.
Adjusting the height
•
The distance to the armrest can be adjusted.
•
Loosen the screw connection on the inner side of the side part
(Fig. 11).
•
Move the control unit into the desired position, then tighten the
screw again.
Bischoff & Bischoff GmbH | Rev. 04 2023.08.25
Eltego
Electric Wheelchair |
9
10
11
59
Publicidad
