Eaton TRIPP LITE Serie Manual Del Propietário página 4

Extender Kit Installation
Note:
1. Test to make sure the entire installation works properly before pulling cables through ceilings/walls.
2. To achieve maximum distance and performance, 24 AWG solid wire Cat5e/6 cable must be used.
The use of stranded wire Cat5e/6 cable or cable with a gauge size higher than 24 AWG will result in
shorter extension distance. All N202-Series Cat6 cables are made with 24 AWG solid wire cabling.
3. Make sure the power to all devices you are connecting is turned off prior to installation.
Blu-ray™
PLAYER
1. Connect the built-in HDMI cable of the transmitter unit to the HDMI source.
2. Optional: Connect an HDMI monitor to the LOCAL port on the
B126-1A1-U transmitter using a P568-Series HDMI Cable.
3. Connect the included USB Micro-B Cable between the transmitter unit and a
USB port on the source or a USB wall outlet.
4. Connect the RJ45 port on the transmitter to the RJ45 port on the receiver using
Cat5e/6 cable.
Note: See the installation diagrams for maximum extension distance and video resolutions.
5. Connect the built-in HDMI cable of the receiver unit to an HDMI monitor input port.
6. Connect the included USB Micro-B cable between the receiver unit and a USB
port on the display or a USB wall outlet.
7. Turn on the power to the HDMI source and HDMI display. The green RJ45 LEDs
on the transmitter and receiver units will illuminate to indicate they are
receiving power. The orange RJ45 LEDs on the transmitter and receiver units
will illuminate to indicate they are receiving a signal from the source.
8. If necessary, adjust the Equalization control on the receiver unit to improve the
video image.
Note: An improper Equalization setting can cause the monitor to display no picture at all.
Try each Equalization setting until an acceptable image is displayed.
4
09-016-93-34F6.indb 4 09-016-93-34F6.indb 4
2
HDMI
DISPLAY
3
1
4
24 AWG SOLID-WIRE
CAT5/6 CABLE
Up to 125 ft. at 1080p
6
5
HDMI DISPLAY
9/15/2023 10:52:29 AM 9/15/2023 10:52:29 AM