Eaton TRIPP LITE Serie Manual Del Propietário página 6

Extender/Splitter Installation
1. Connect the HDMI source to the INPUT port on the B126-002 or B126-004
using a P568-Series HDMI Cable.
2. Optional for B126-004: Connect an HDMI monitor to the LOCAL port on the
B126-004 using a P568-Series HDMI Cable.
3. Connect the external power supply to the transmitter unit and plug it into an
Eaton Tripp Lite series Surge Protector, PDU or UPS. The green LED illuminates
to indicate the unit is receiving power from the external power supply.
4. Using Cat5e/6 cable, connect one of the RJ45 output ports on the transmitter
unit to the RJ45 input port on the B126-1A0-U.
5. Connect the B126-1A0-U to a monitor using its built-in HDMI Cable.
6. Connect the included USB Micro-B cable to the port on the
B126-1A0-U and a USB port on the display or a USB wall outlet. The green LED
will illuminate, indicating the unit is receiving power from the USB Micro-B port.
7. Repeat Steps 4-7 for each additional B126-1A0-U in the installation.
8. Turn on the power to the HDMI source and HDMI displays. The orange RJ45
LEDs illuminate on both transmitter and receivers to indicate the unit is
receiving a signal from the source. The screen should now be displayed on the
connected monitors.
9. If necessary, use the Equalization control on the B126-1A0-U to adjust the
video image.
Note: An improper Equalization setting can cause the monitor to display no picture at all.
Try each Equalization setting until an acceptable picture is displayed.
6
09-016-93-34F6.indb 6 09-016-93-34F6.indb 6 9/15/2023 10:52:30 AM 9/15/2023 10:52:30 AM