cecotec BOLERO COOLMARKET FD 510 DARK E Manual De Instrucciones página 64

ENGLISH
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the Official Cecotec Technical Support Service
immediately.
- This refrigeration appliance is not suitable for built-in installation.
- Remove all packaging, including the plastic protection on the bottom of the appliance and
the adhesive tape securing the shelves and door compartments inside.
- Place the refrigerator in a suitable position and adjust the feet to level it. It is recommended
to clean the appliance with a hot, soapy cloth and dry it thoroughly before use.
- Place the refrigerator and adjust its height, clean it, let it rest for 4 to 6 hours, and switch
it on. This will help ensuring that the compressor oil has properly settled, and that the
appliance is running normally.
3. OPERATION
Installation size. Fig. 3
Select an appropriate level-surfaced location to place your appliance for easy use. Avoid
placing the appliance near heat sources, under direct sunlight, or in moist environments.
A (mm) B (mm) C (mm)
621 836
- The above values are indicative for installation purposes. Actual sizes may vary slightly.
- To ensure that the appliance runs at maximum efficiency, allow enough space around the
appliance as shown in Figure 4.
Installation location
- The refrigerator must be placed on a solid, flat surface.
- If cushioning is necessary, use stable, solid, and non-flammable cushioning blocks.
- DO NOT USE FOAM PACKAGING AS CUSHIONING BLOCKS!
- The appliance should be kept away from damp or wet environments. Water or dirt should
be removed from any surface of the appliance as soon as possible with a soft cloth. This
will help prevent rust and help your appliance run at maximum efficiency.
- Place the refrigerator in a well-ventilated place, reserve some space around and behind
the refrigerator, and do not cover or block the air grille of the compressor rear cover plate
64
BOLERO COOLMARKET FD 510 INOX E / DARK E / WD INOX E / GLASS E
D (mm)
1774 1830
E (mm) F (mm)
706 1521
Height (mm) M (mm)
382 1076