Publicidad
Idiomas disponibles
Idiomas disponibles
5.1. CONNECTING LEADS
INSTRUCTIONS FOR CONNECTING LEADS
MMA WELDING MODE
1.
Use welding mode selection button to select MMA welding mode (MMA welding mode light will come on).
2.
Connect the return lead to the socket marked with „+", and tighten the locking nut.
3.
Then connect the welding lead to the correct socket, marked with the „–" sign and tighten the locking
nut. WARNING! Polarization of the leads may be different! All polarisation information should be
shown on the packaging supplied by the electrode manufacturer!
4.
Now you can connect the power lead and turn the power on, once the return lead is connected to the
welded element, you can start working.
TIG WELDING MODE
1.
Use welding mode selection button to select Lift TIG welding mode (LIFTTIG welding mode light will
come on).
2.
Connect the return lead to the socket marked with „+", and tighten the locking nut.
3.
Then connect the TIG welding lead to the socket marked with the „–" sign, connect the TIG welding
control lead and tighten the locking nut. Connect the gas lead directly to the gas canister. Gas flow is
adjusted using the knob on the welding torch.
4.
Now you can connect the power lead and turn the power on, once the return lead is connected to the
welded element, you can start working.
MIG WELDING MODE
1.
Use welding mode selection button to select MIG welding mode (MIG welding mode light will come on).
2.
Connect the return lead to the socket marked with „-", and tighten the connecting locking nut.
3.
Connect the electrode to the „+" plus socket.
Polarization of the leads may be different depending on the welding material.
4.
Insert a correctly selected filler wire and connect the gas canister to the back of the machine.
6. DISPOSING OF PACKAGING
The various items used for packaging (cardboard, plastic straps, polyurethane foam) should be kept, so that
the device can be sent back to the service centre in the best possible condition in case of any problems!
7. TRANSPORTATION AND STORAGE
Shaking, crashing and turning upside down of the device should be prevented when it is transported. Store it
in a properly ventilated surrounding with dry air and without any corrosive gas.
8. CLEANING AND MAINTENANCE
•
Always unplug the device before cleaning and when the device is not in use.
•
Use cleaner without corrosive substances to clean surface.
•
Dry all parts well before the device is used again.
•
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
9. CHECK REGULARLY THE DEVICE
Check regularly that the device doesn ́ t present any damage. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
•
Invoice number and serial number (the latter is to be found on the technical plate on the device).
•
If relevant, take a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better the
customer service will be able to answer your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
EN
16
Rev. 24.07.2017
PL
Publicidad
