FALMEC ALTAIR WALL Manual De Instrucciones página 28

are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CHARCOAL FILTERS
These trap the odours present in the stream of air that passes through them. The air is purified
by passing a number of times through the filters and being recirculated into the kitchen. The
charcoal filters cannot be cleaned, and should be replaced on average every 3-4 months (ac-
cording to use). To replace the charcoal filters, see the instructions in point H2.
3. CLEANING THE OUTSIDE OF THE APPLIANCE
It is advised to clean the external hood surfaces at least every 15 days in order to avoid
that oily or greasy substances affect the steel surfaces.
The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid
detergent or denatured alcohol.
In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using
clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain
abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using
abrasive substances or rough cloths will inevitably damage the finish of steel. The steel
surface will be irrevocably damaged if the instructions above are not complied with. Keep
these instructions together with the instructions for use of your hood.
The manufacturer accepts no liability for any damage caused by non-compliance with the
instructions above.
4. CLEANING THE INSIDE OF THE APPLIANCE
The electrical parts or parts of the motor assembly inside the range hood must not be
cleaned using liquids or solvents.
Do not use abrasive products.
All the above operations must be performed after having disconnected the appliance from the
mains power supply.
M
WARRANTY
The new equipment is covered by warranty.
The warranty conditions are provided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or
transcription errors. The manufacturer reserves the right to modify its products as it consid-
ers necessary or in the interests of the user, without compromising their essential safety and
operating characteristics.
N
HOODS MOUNTING INSTRUCTIONS
WARNING: Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards.
ALTAIR WALL HOOD ASSEMBLY
Phase 1
- Place on the wall support bar (A) (Fig. 1), at the same height of the cooker resulting from the
sum of the heights X + 260 mm.
- With a spirit level, verify the horizontal alignment and mark two drilling points at the edges of
bar n. 2.
- Drill, insert n. 2 expansion bolts of 8 mm Ø and fasten the bar with the relative screws.
21