DeWalt D28720 Manual De Instrucciones página 32

FIG. 3
BLOCK
Spark Defl ector Adjustment (Fig. 1)
To best deflect sparks away from surrounding persons and materials,
loosen the screw (B), adjust the spark deflector (C) and then retighten
screw. Do not allow cordset to come into contact with deflector or
sparks as damage to cordset may occur.
Vise Operation (Fig. 4)
The vise (F) has a quick-travel feature. To release the vise when it is
clamped tightly, turn the crank (H) counterclockwise one or two times
to remove clamping pressure. Lift vise lever (I) up. Pull crank assembly
out as far as desired. Vise may be pushed forward into work without
cranking. Lower vise lever (I) then tighten vise (F) on work by using
crank (H).
FIG. 4
CUT-OFF
END
Fence Operation (Fig. 5, 6)
The fence (E) can be adjusted two ways: to change desired cutting
angle and to change spacing between the fence and vise.
TO CHANGE THE DESIRED CUTTING ANGLE
Use the wrench provided to loosen (do not remove) the two fence
bolts (Q). Align the desired angle indicator line with the slot line (R) in
the base (D). Securely tighten both fence bolts before use.
For more accurate square cuts, disconnect the power supply, loosen
the two fence bolts, push arm down until wheel extends into base.
Place a square against the wheel and adjust fence against the square.
Securely tighten both fence bolts before use.
When making a miter cut, the vise (F) may not clamp securely,
depending on the thickness of the workpiece and the miter angle.
Other aids (such as spring, bar or C-clamps) will be necessary to
secure the workpiece to the fence when making these cuts.
30
E
FORWARD
F
I
H