Cutting Capacity - DeWalt D28720 Manual De Instrucciones

soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. ALL USERS AND BYSTANDERS MUST
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. D WALT tools are factory tested; if this tool does not
E
operate, check power supply.

Cutting Capacity

The wide vise opening and high pivot point provide cutting capacity
for many large pieces. Use the cutting capacity chart to determine
total maximum size of cuts that can be made with a new wheel.
CAUTION: CERTAIN LARGE, CIRCULAR OR IRREGULARLY
SHAPED OBJECTS MAY REQUIRE ADDITIONAL HOLDING
MEANS IF THEY CANNOT BE HELD SECURELY IN VISE.
CAUTION: DO NOT CUT MAGNESIUM WITH THIS TOOL.
MAXIMUM CUTTING CAPACITY
NOTE: Capacity shown on chart assumes no wheel wear and
optimum fence position.
Workpiece
Shape
90° Cutting A = 4-7/8" A = 4-1/2"
Angle
(125 mm) (115 mm)
45° Cutting A= 4-1/2" A =
Angle 3-13/16"
(115 mm)
(98 mm)
DESCRIPTION (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Lock Chain
B. Spark deflector screw
C. Spark deflector
D. Base
E. Fence
F. Vise
G. Flat Wrench
H. Crank
I. Vise Lever
28
A x B A = 4-1/2" x 5-3/8"
4-1/2" x 5-1/8" (115 mm x 137 mm)
(115 mm x 130 mm)
4" x 7-5/8"
(102 mm x 188 mm)
3" x 7-3/8"
(76 mm x 229 mm)
4-1/8" x 3-3/4" A =
(105 mm x 95 mm) 3-3/4" (95 mm)
J. Wheel
K. Guard
L. Spindle Lock
M. Depth Stop
N. Trigger Switch
O. Padlock Hole
P. Jam Nut
Q. Fence Bolts