Publicidad
Idiomas disponibles
Idiomas disponibles
suggesTIOns
Divide the articles to be ironed according to the types of material: wool with wool, cotton with cotton, etc
Because the iron heats up much more quickly than it cools down, it is advisable to start with those fabrics which require
lower temperatures and move on to those which require progressively higher temperatures. If the material is made up of
more than one type of fibre, always set the temperature to the fibre which requires less heat. For example, if the material
is made up of 70% synthetics and 30% cotton, set the temperature control to position (
the temperature for synthetic fabrics.
Label Ironing
Kind of fabric
instructions
Synthetic fabrics:
Acetate
Acrylic
Viscose
Poliammide (Nylon)
Viscose (Rayon)
Silk
Wool
Cotton
Linen
The mark on the label means do not iron
If you do not know the composition of the article to be ironed, choose a part of the article which will not be seen. Do a test
ironing on this part to establish the appropriate temperature (always start with a relatively low temperature and work up until
the ideal temperature is reached). Pure (100%) wool articles can be ironed with the iron set to one of the steam positions.
To avoid pure wool, silk and synthetic materials becoming shiny, it makes good sense to iron them on the reverse side. For
other materials, especially velvet, which can become shiny very easily, cover them with a cloth and iron in one direction only,
using light pressure. The iron must be kept constantly moving over the fabric.
cleAnIng AnD MAInTenAnce
Warning!
Before cleaning, always disconnect the plug from the power point and allow the iron to cool down on its stand grille.
Warning!
Never immerse the appliance in water or other liquids.
Warning!
Check the state of the power cable of your iron on a regular basis before using it, and if it is damaged, take it to the
service centre closest to you to have it replaced only by specialised personnel.
cleaning the soleplate
Any deposits and other residue material on the soleplate can be removed using a cloth soaked in a water and vinegar solu-
tion. Always dry the soleplate with a dry cloth.
Warning!
Do not use abrasives for cleaning the soleplate. Try and keep the soleplate smooth: avoid contact with metal objects.
Iron tank cleaning
Occasionally clean the tank of the iron (M) by inserting fresh water (Fig. 17). Rinse and empty (Fig. 18).
Warning!
Do not put vinegar, decalcifying agents or other fragrant substance in side the tank; Otherwise, the warranty may
be revoked.
plastic parts cleaning
Clean plastic parts with a damp, non-abrasive cloth and dry them with a dry cloth.
Thermostat
•
••
•••
•
) (see table) without steam, that is,
17
Publicidad
