Publicidad
Idiomas disponibles
Idiomas disponibles
•
The position of the lateral window in the control
cage.
•
Different types and hardness of the surface.
To adjust the blast pattern
WARNING:
touch the cage clamps or the blast wheel
blades when the product is on. Disconnect
the power supply when you adjust the blast
pattern.
WARNING:
equipment when you adjust the blast
pattern. Refer to
equipment on page 7 .
1. Open the separator door and look if there is abrasive
material in the hopper. If there is abrasive material
in the hopper, empty it. Refer to
material from the hopper on page 20 .
2. Disconnect the power plug.
3. Remove the 8 screws, the 16 washers, the 8 nuts
and the hopper.
4. Loosen the cage clamps.
2107 - 001 - 27.07.2023
Do not adjust, loosen or
Use personal protective
Personal protective
To remove abrasive
5. Examine the position of the control cage window.
6. Turn the control cage clockwise, if the hotspot is too
much on the right side.
17
Publicidad
