Publicidad
Idiomas disponibles
Idiomas disponibles
To attach the product to a
transportation vehicle
Use the lifting eyes to attach the product to the
transportation vehicle.
1. Attach the tie-down straps in the lifting eyes.
2. Attach and tighten the tie-down straps to the
transportation vehicle.
To lift the product
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the work area.
WARNING:
product. Make sure that the lifting eyes are
correctly installed and not damaged.
1. Attach the lifting equipment to the lifting eyes.
2. Lift the product safely. Hold the handle until the
product is off the ground.
To disassemble the product
To move the product through small openings you can
disassemble the product.
1. Disconnect the product from the power supply.
2. Remove the dust collector hose.
3. Cut the cable ties that hold the power supply cables.
28
Make sure that the lifting
Do not walk or stay below
Do not lift a damaged
To remove the impeller on page 20 .
4. Do the steps in
To remove the blast wheel blades on
5. Do the steps in
page 22 .
6. Do one of the steps that follow:
a) For EBE 500 50 Hz: Remove the electrical
enclosure.
b) For EBE 500 60 Hz: Remove the weights and
weight brackets.
2107 - 001 - 27.07.2023
Publicidad
