Husqvarna EBE 500 Manual Del Usuario página 18

7. Turn the control cage counterclockwise, if the
hotspot is too much on the left side.
8. Make sure that the hotspot is equally applied on the
surface for correct adjustment.
18
9. Tighten the cage clamps when the control cage is in
correct position.
To stop the product
1. Close the valve for the abrasive material. Refer to
operate the valve for the abrasive material on page
12 .
2. Push the stop button for the blast motor (A), the fan
unit (B) and the drive motor (C).
3. Turn the ON/OFF switch to the OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust collector. Refer to the operator's
manual of the dust collector.
To
A
B
C
2107 - 001 - 27.07.2023