Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The wear is more
than usual on parts of
the housing.
The product does not
move.
The control system
does not start.
The control system
stops during opera-
tion.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
CAUTION:
behind a vehicle.
•
Disconnect the electrical cable and dust collector
hose before transportation.
•
Remove the abrasive material before transportation.
To remove abrasive material from the
Refer to
hopper on page 20 .
•
Put some type of protection on the product
during transportation. The protection keeps natural
elements, for example rain and snow, away from the
product during transportation.
2107 - 001 - 27.07.2023
Cause
The type of abrasive material is incorrect.
The control cage is not installed correctly.
The suction power of the dust collector is not
sufficient.
The operation speed is too low.
The control unit is damaged.
The potentiometer is damaged.
The fuse is damaged.
There is a short circuit in the drive motor.
There is a short circuit in the tachometer.
The blast motor is damaged.
The motor protection switch is engaged.
The power supply cable is damaged.
The cable between the product and the dust
collector is damaged.
The motor protection switch is engaged.
The dust collector stops because of over-
load.
Transportation, storage and disposal
Be careful during
Do not tow the product
Solution
Speak to your dealer for more information.
Adjust the control cage to set a better blast
pattern.
Do a check of the dust collector hose and the
dust collector.
Increase the operation speed.
Replace the control unit.
Let an approved electrician replace the po-
tentiometer.
Let an approved electrician do a check.
Start the product again. Do a check of the
power supply.
Replace the cable.
Replace the cable.
Let an approved electrician do a check.
Let an approved electrician do a check.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING:
slope, always use a winch. Do not walk or
stay below or near the product.
•
To move the product down a ramp, operate the
product forward slowly.
•
To move the product up a ramp, operate the product
rearward slowly.
•
Do not turn the product to the left or to the right more
than 45° on a ramp.
Be very careful when you
For ramps with a steep
27
Publicidad
