Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Final rinse
Start the final rinse from bottom to top. Make sure that the surface is well rinsed and that all
dirt has been removed.
Turning off
- Make sure there is no detergent in the system.
- Turn off the motor. Turn off the water supply.
- Once the product and the water supply have been turned off, press the trigger to
depressurise the device.
- After each use, wipe the surface of the pressure washer with a clean, damp cloth.
Warning
- Do not turn off the water supply until the motor has been switched off, as this could
cause serious damage to the pump and motor.
- Do not remove the high pressure hose from the machine while the system is being
pressurised. To depressurise the device, turn off the motor and water supply and press
the trigger 2 or 3 times.
Tips for extending the product shelf life
- Do not use the product without water.
- Do not use the product with hot water.
- Before setting the spray nozzle pressure (high to low or low to high), release the trigger.
- Never use the unit for more than 1 minute without spraying water.
5. CLEANING AND MAINTENANCE
- The machine must be switched off and disconnected from the mains for cleaning or
maintenance.
- Do not store the pressure washer outdoors or where it can freeze, the pump could be
severely damaged.
66
HYDROBOOST 1500
6. TROUBLESHOOTING
Problem
Cause
Smoke comes out of the
Overheating, overloading or
appliance.
motor failure.
There is not enough pressure.
The inlet water filter is
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge valve
is worn or not the correct
size.
The pressure washer does
The unit is pressurised.
not turn on.
The plug is not properly
connected or the socket is
defective.
The extension cord is too long
or short.
The supply voltage is too low.
The thermal safety switch
has tripped.
Pressure fluctuates.
The pump is sucking in air.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
The motor stops suddenly.
The extension cord is too long
or short.
The thermal safety
switch has tripped due to
overheating.
ENGLISH
Solution
Switch off the device
immediately and contact
the Technical Support
Service of Cecotec.
Clean the inlet water filter.
Check that the connections
and the locking ring are tight.
Contact the official Technical
Support Service of Cecotec.
Press the gun trigger.
Check the plug,
the socket and fuses.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
Switch off the device and
allow it to cool down.
Check that hoses and
connections are tight.
Clean them with the cleaning
clip.
Contact the official Technical
Support Service of Cecotec.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
HYDROBOOST 1500
67
Publicidad
