device, turn it off, stop the water supply, and then press the
trigger 2 or 3 times.
- Do not activate the trigger locking system while the machine
is in operation.
- Do not operate the appliance unless all parts are properly
connected to the main body (handle, gun, nozzle, etc.).
- Make sure to turn on the water supply before turning on
the pressure washer. Running the pump without water can
cause serious damage to the pump.
- Do not use the pressure washer if any parts are missing or
damaged. Check the condition of the product regularly and
repair or replace damaged or worn parts immediately.
- Use only original spare parts supplied or recommended by
Cecotec to ensure safe operation.
- Use only the nozzle included with the product.
- Do not leave the high-pressure hose unattended while the
device is operating.
- Hold the high-pressure hose and gun firmly when switching
on and while using the machine.
- Do not leave the unit running with the trigger released for
more than one minute, as this could damage the pump.
- This device is not designed to pump hot water. Do not
connect to a hot water supply as this will significantly reduce
the shelf life of the pump.
This symbol means that this device is not suitable to
-
be connected to drinking water sources.
- Make sure the water inlet pressure is between
0.01 MPa and 0.4 MPa and that the inlet hose is at
least 5 metres long.
- If the device is to be connected to a drinking water supply,
install a disconnector on the water pipe to prevent dirty
water from backing up and entering the drinking water
12
HYDROBOOST 1700 CAR&BIKE
system. The disconnector shall comply with EN 60335-2-79
ANNEX A.
- Water that has flowed through backflow prevention devices
is considered non-drinkable.
- This device must not be controlled by external switching
elements such as timers or connected to electrical circuits
that are continuously switched on and off.
- Release the trigger when switching from high to low
pressure.
- Spray nozzle setting.
- Keep the high-pressure hose away from sharp objects. The
burst of a high-pressure hose could cause injury. Inspect the
high-pressure hose regularly and replace it if necessary. Do
not try to fix a damaged high-pressure hose.
- Keep all connections dry and off the ground to avoid risk of
electric shock. Do not touch the plug with your hands wet.
- Do not use a higher pressure than that permitted by the
parts of the pressurisation system (high-pressure hose,
connections, etc.). Make sure every component and
accessory is rated to withstand the maximum operating
pressure of the unit.
- The appliance should not be used by children. Children
must be supervised to make sure they do not play with the
appliance.
- This appliance can be used by persons with reduced physical,
sensory, or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning the use of the appliance in a safe way and
understand the hazards involved.
- High-pressure cleaning devices should not be used by
children or untrained personnel.
13
HYDROBOOST 1700 CAR&BIKE