Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
1. PARTS AND COMPONENTS
Fig.1
1.
Main body
2.
Hose
3.
Water supply
4.
Water inlet
5.
High-pressure hose
6.
Water outlet
7.
Trigger gun
8.
Power socket
9.
ON/OFF switch
10. Wand
11.
3D Turboflip nozzle
12.
Spraying nozzle
*Parts 2, 3 and 8 not included.
2. BEFORE USE
-
Ensure that all components are included and in good conditions. If any sign of visible
damage is observed or any of the product's parts are missing, immediately contact the
official Technical Support Service of Cecotec.
-
Fit the high-pressure hose to the pressurised water outlet of the machine.
-
Attach the gun to the high-pressure hose. Before operating the machine, make sure that
the high-pressure hose is completely uncoiled. The high-pressure hose should not tangle
while in use.
-
Install the spray nozzle or the item to be used.
-
Connect the machine to the power supply and to the water supply.
3. OPERATION
Setting the water pressure
The angle of the water jet can be set with the spray nozzle by turning the tip. This will cause the
jet to vary from approximately 0° (narrow high impact jet) to 60° (wide spray jet).
Fig. 2
H Y D R O B O O S T 1400 EASYMOVE
60
This device has 3 modes:
Concentrated mode
The angle of the water jet can be set with the spray nozzle. Rotate the nozzle to select the
direct jet, which has a high impact on the surface to be cleaned and provides thorough cleaning
of concentrated areas. This jet must be carefully used, as it can damage surfaces.
Warning
Pay special attention when cleaning surfaces susceptible to damage, such as vehicle bodywork
or rims, lacquered surfaces, wood, paintwork, etc.
Fig. 3
Spray mode
Turn the spray nozzle to select the fan spray pattern to cover large areas. This cleaning mode
offers excellent results without the risk of damaging surfaces. By using a wide spray pattern,
larger areas can be cleaned more quickly.
Fig. 4
Turbo mode
Use the 3D TurboFlip nozzle to clean with a turbo mode. Water is distributed in a spiral-
shaped jet. The 3D TurboFlip nozzle combines the power of a direct jet of great impact with the
efficiency of a 25º jet. This transforms the concentrated jet into a conical jet that deep cleans
larger areas.
Fig. 5
Product performance
Warning
The motor of this pressure washer does not run continuously. It only runs when pressing the
trigger. Once the initial procedures in this manual have been carried out, turn the pressure
washer on and press the trigger to activate the pressure washer.
Nozzle cleaning
-
A clogged or partially clogged nozzle can significantly reduce water output and cause
intermittent jetting. To clean the nozzle:
-
Turn off and unplug the unit.
-
Disconnect the water supply. Press the trigger 2 or 3 times to release the pressure trapped
in the hose.
-
Disassemble the wand.
-
Turn the nozzle to concentrate mode, this will activate the internal blades.
-
Use the cleaning kit provided, or any sharp item to clean the nozzle, e.g. insert an unfolded
ENGLISH
H Y D R O B O O S T 1400 EASYMOVE
61
Publicidad
