Descargar Imprimir esta página

cecotec HYDROBOOST 1400 EASYMOVE Manual De Instrucciones página 33

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
ENGLISH
5. TROUBLESHOOTING
Problem
Cause
Smoke comes out of the
Overheating, overloading or
appliance.
motor failure.
There is not enough
The inlet water filter is
pressure.
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge
valve is worn or not the
correct size.
The pressure washer does
The unit is pressurised.
not turn on.
The plug is not properly
connected or the socket is
defective.
The extension cord is too
long or short.
The supply voltage is too
low.
The thermal safety switch
has tripped.
Pressure fluctuates.
The pump is sucking in air.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
H Y D R O B O O S T 1400 EASYMOVE
64
Solution
Turn off the device
immediately and contact the
Technical Support Service of
Cecotec.
Clean the inlet water filter.
Check that the connections
and the locking ring are
tight.
Contact the Technical
Support Service of Cecotec.
Press the gun trigger.
Check the plug, the mains
and the fuses.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
Switch off the device and
allow it to cool down.
Check that hoses and
connections are tight.
Clean it with the cleaning kit.
Contact the Technical
Support Service of Cecotec.
Contact the Technical
Support Service of Cecotec.
The motor stops suddenly.
The extension cord is too
long or short.
The thermal safety
switch has tripped due to
overheating.
6. TECHNICAL SPECIFICATIONS
Model: HidroBoost 1400 EasyMove
Product reference: 05401
1400 W, 220-240 V~ 50/60 Hz
Pressure: 7 MPa - 70 bar
Max. pressure: 10.5 MPa - 105 bar
Flow: 5.5 l/min (330 l/h).
Maximum flow: 6.8 l/min (408 l/h).
5 ºC - 50 ºC IPX5
Manufactured in China | Designed in Spain
7. DISPOSAL OF OLD ELECTRICAL APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or battery must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the batteries/accumulators and take them to a collection point designated
by the local authorities. 
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help to protect the environment.
8. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
time of delivery of the product under the terms, conditions and deadlines established by the
ENGLISH
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
H Y D R O B O O S T 1400 EASYMOVE
65

Publicidad

loading

Este manual también es adecuado para:

05401