Descargar Imprimir esta página

cecotec Cumbia POWER ESPRESSO 20 Manual De Instrucciones página 22

Cafetera espresso
Ocultar thumbs Ver también para Cumbia POWER ESPRESSO 20:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
ENGLISH
-
To get larger bubbles, insert the steamer by about 2 cm into the milk.
-
To generate a denser foam with smaller bubbles, insert steamer 1 cm into the milk and tilt
it, placing the steamer spout on the lower side of the jug.
-
When finished, turn the steam knob to the off position and press the steam button again
to deactivate the function. 
Warning: clean the steam outlet with a wet sponge immediately after use. Then, remove the
steamer and clean the inner duct. It is also recommended to emit steam again to clean possible
milk remaining inside the tube.
-
Pour frothed milk into the espresso to prepare cappuccino. 
Note: it is recommended to allow the appliance to cool down for at least 5 minutes before
brewing coffee again. Otherwise, your espresso might have a light burnt odour. 
Dispensing hot water
-
Press the coffee button and make sure the steam knob is off. The indicator light will stop
blinking once the coffee machine reaches the desired temperature. 
-
Turn the steam knob counterclockwise (at least 135º). Then, press the middle button. Hot
water will flow out from the steam outlet. 
Steam-heating other liquids
-
The steamer (without the tube) can be used to heat beverages like hot chocolate, water,
or tea.
-
Remove the detachable water tank, open the tank cover, and fill it up. The water level
should not exceed the "MAX" mark in the tank. Install the tank back in the device.
-
Plug the coffee machine to a power supply. Make sure the steam knob is in the off position.
Press the steam button and the indicator light will start blinking. Wait until the light stops
-
blinking.
Remove the steamer from the steam outlet.
-
Insert the steam outlet in the drink you wish to heat up. Slowly turn the steam knob
-
counterclockwise to release steam.
When the required temperature is reached, turn the steam knob to the off position.
-
Press the steam button again to turn the device off.
-
4. CLEANING AND MAINTENANCE
-
Turn off, unplug the appliance, and let it cool down before cleaning it. 
-
Clean the housing of the appliance with a wet cloth. Empty the water tank and drip tray and
clean them together with the removable grille. Dry them thoroughly. 
42
POWER ESPRESSO 20
Note:
Do not clean the appliance with alcohol or solvents. Do not immerse the main body of
the appliance in water. 
-
Clean the portafilter and the stainless-steel filter under running water. 
Cleaning mineral deposits
Clean the mineral deposits every 2-3 months to ensure that the coffee machine operates
properly, that the internal piping is clean, and that coffee flavour is good. 
1.
Fill the tank with water and descaler up to the "MAX" mark (use the measure recommended
by the product manufacturer).
2.
Insert the stainless-steel filter into the filter holder without ground coffee in it and attach
it to the main body as indicated in previous sections. Place a jug under the filter holder.
Make sure the steam knob is in the off position. 
3.
Press the preheating-function button and wait until the indicator light stops blinking.
4.
Then, press the coffee button and dispense about 500 ml (20 fl. oz.) of liquid. Press the
coffee button again to stop and wait for 5 seconds. 
5.
Press the steam button and wait until the indicator light stops blinking. Turn the steam
knob counterclockwise to release steam for 2 minutes. Then, turn the steam knob to the
off position and press the steam button again to stop. Allow the coffee machine to cool
down for 15 minutes. 
Restart the coffee machine and repeat steps 4 and 5 at least 3 times. 
-
Press the preheating-function button and wait until the indicator light stops blinking.
-
Then, press the coffee button and dispense liquid until the water tank is empty. 
Fill the tank with clean water up to the "MAX" mark and repeat steps 4 and 5 at least 3
-
times.
5. TROUBLESHOOTING
Error 
Possible cause
No coffee comes out /
Remains of mineral
Very little coffee comes
deposits in the device.
out / Coffee comes out
Coffee was pressed
unpressurised.
excessively / Coffee is too
finely ground.
Coffee is watery.
The coffee was too lightly
pressed. / Coffee is too
coarsely ground.
ENGLISH
Possible solution
Perform a complete descaling
(Section 5.).
Do not exert too much pressure when
pressing the coffee into the filter. /
Use more coarsely ground coffee.
Apply more pressure when pressing
the coffee into the filter. / Use more
finely ground coffee.
POWER ESPRESSO 20
43

Publicidad

loading

Este manual también es adecuado para:

01503