Publicidad
Idiomas disponibles
Idiomas disponibles
3-WIRE SYSTEM
CONNECTIONS
1. Loosen or remove center terminal
block screw.
2. Connect
neutral wire (white or center wire) of power supply cord to the center, silver
colored terminal
screw of the terminal block. Tighten screw.
3. Connect
the other wires to outer terminal
block screws. Tighten
screws.
4. Tighten
strain relief screws.
5. Insert tab of terminal
block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
4
5
1. External
ground
connector
2. Neutral grounding
wire (green/yellow)
3. Center silver-colored
terminal
block screw
4. Neutral wire (white or center wire)
5. 3/4 in. (1.9 cm) UL-listed
strain relief
WARNING:
If converting
from a 4-wire electrical
system to a 3-wire, the ground
strap
must be reconnected
to the terminal block support to ground the dryer frame to the
neutral conductor.
4-WIRE SYSTEM
CONNECTIONS
1. Remove center terminal
block screw.
2. Connect
ground wire (green or bare) of power supply cord to external
ground conductor
screw.
3. Connect
neutral wire (white or center wire) of power supply cord and appliance
ground
wire (green with yellow stripes)
under central screw of the terminal
block.
4. Connect
the other wires to outer terminal
block screws. Tighten
screws.
5. Tighten strain relief screws.
6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down
screw.
5
6
1. External
ground connector
2. Green or bare copper
wire of power supply cord
3. 3/4 in. (1.9 cm) UL-listed
strain relief
4.Center
silver-colored
terminal
block screw
5 Grounding
wire (green/yellow)
6. Neutral
wire (white or center wire)
EXPORT
MODELS
Refer to last page of installation instructions.
10
Publicidad
