Publicidad
DISPLAY/
CLOCK ADJ
DISPLAY/
CLOCK ADJ
DISPLAY/
CLOCK ADJ
18
<ARE7108>
En
SETTING THE CLOCK
e@When the power plug is first connected, the unit automatically
enters the demo (demonstration) display mode. Keep pressing
the P.BASS
(DEMO)
button for three seconds to cancel the
demonstration mode. When set to the OFF (STANDBY) position,
the clock display appears.
e Set the clock when it has been incorrectly set or when power
has been cut to the unit.
e This clock provides a 24 hour display.
e@The clock cannot be set by the remote control unit.
Example : Setting the clock to 6:40
1. While power is turned off, keep the DISPLAY/CLOCK ADJ
button pressed for more than 3 seconds.
2. Set the hour by quickly pressing and releasing the ©) or
button, then press the DISPLAY/CLOCK ADJ button.
3. Set the minutes by quickly pressing and releasing the © or
button.
4. Press the DISPLAY/CLOCK ADJ button, when "00" seconds
of that minute are reached for precise adjustment.
e@After connecting to an AC outlet, be sure to set the present
time. Timer playback and timer recording are not possible
unless the time has been set.
eThe time display will appear as "--:--" when the power is
restored following a power failure, or if the power cord has
been disconnected. In this case, be sure to set the present time
again.
TURNING ON THE POWER
Operations indicated by the ({j mark are performed with the
remote control unit.
Confirm the speakers and antenna connections by reading the
section "CONNECTIONS" again.
e@ When the power plug is connected into an AC wall outlet, the unit
enters the demonstration mode. Keep pressing the P.BASS (DEMO)
button for three seconds to cancel the demonstration mode.
Press the POWER switch (or POWER button on the
remote control unit).
To switch the power OFF:
Press the POWER
switch again.
The clock display reappears. A function indicator also continues
illuminating.
Direct power on
eWhen set to the OFF (STANDBY)
position, the following
operations will turn on the power.
1. Pressing the TUNER/BAND button:
AM or FM radio broadcast will be received.
2. Pressing the CD button:
if a CD is loaded, playback will begin.
3. Pressing the AUX button:
If the component connected to the AUX jack is operated,
sound will be output.
4. Pressing the TAPE I/II button:
If you press the TAPE button, power switches ON. Playback
starts if there is a tape loaded.
5. Pressing the MEMORY button:
The function selected when
power was switched
off
automatically operates, and play begins.
6. Pressing the OPEN/CLOSE button:
Press this to eject the disc tray.
Publicidad
