Publicidad
Idiomas disponibles
Idiomas disponibles
1. Connect the power source input cable of welding machine with the output port of air switch in electric
box on the spot.
2. Connect the cable plug of wire feeder to the positive output of welding machine.
3. Connect the control cable plug of wire feeder to the aero socket on the front board of welding machine.
4. Connect the negative pole of welding machine to the work piece (base metal).
5. Connect the heating power cable of gas cylinder to the 36V gas heating power socket on the back panel
of welding machine.
6. Connect the output pipe of gas cylinder to the input joint of gas valve on the wire feeder and clamp it.
7. Insert the torch joint into the output of wire feeder unit and keep the wire aim at the wire feeder mouth.
Note: The plane of the joint should be aimed at screw, plugged tightly and rotated 90º, then screw the bolt
tightly to ensure the torch contacting closely.
8. Connect the shielded gas pipe of torch with the output of front panel on wire feeder.
9. Connect the control cable pin of torch with the two-lead aero socket of front panel on wire feeder.
10. Notice that the wire diameter should be accordant with the wire wheel and torch tip and press the wire
properly with the handle.
3.4 Maintenance of MIG torch mechanism
3.4.1 Dissection graphics for the MIG torch
4
5
6
9
10
11
3
2
1
3.1
8
7
1 9
1 8
1 7
1 6
1 5
1 3
1 2
1 4
Torch consumables depend on the wire diameter and to be used. Contact your local importer or
distributor for their supply.
10
SWEISSWELD.COM
Publicidad
