Publicidad
Idiomas disponibles
Idiomas disponibles
Straighten the wire end for approximately 20 cm and cut the wire in the straightened location. Open the
pressure control level which then opens the feed gear. Thread the wire through the wire's rear guide to
the torch's wire guide. Close the feed gear and fasten it with the pressure control lever. Make sure that
the wire runs in the feed roll groove. Adjust the compression pressure with the pressure control lever no
higher than to the middle of the scale. If the pressure is too high, it removes metal fragments from the wire
surface and may damage the wire. On the other hand, if the pressure is too low, the feed gear slips and the
wire does not run smoothly.
Press the welding torch trigger and wait for the wire to come out.
4. Operación
4.1 Diagrama para panel frontal y trasero
3
4
S c h w e i s s t e c h n i k
5
POWER
ALARM
6
9
8
7
10
11 12 13 14
15
16
17
18
19
20
21
22
1. Current display: Welding Current display when machine is working, Set
current display before welding. Unit ： A.
2. Voltage display: Welding voltage display when machine is working, Set
voltage display when MIG mode before welding. Unit ： V.
3. Alarm Led: When the welder is over voltage, less voltage, over current or over
heated, the alarm pilot lamp will be on.
4. Power Led: Power led is lighted when open the machine.
5. Welding current knob: Set the welding current.
6. Welding voltage/Down slope/Arc force knob: On MIG, When the program
voltage can't perfectly match the welding current, the knob can adjust voltage
On TIG, the knob can adjust the current down time. On MMA, the knob can
adjust the force current.
7. Wave control knob: Controls arc characteristics, Determines the rate at which
the amperage rises when a short circuit is produced.
8. Choose welding material diameter key
9. Choose welding material key
10. Choose welding mode key: On TIG or MIG, Pressing the key can choose 2T
or 4T welding mode.
11. Choose welding method key: Pressing the key can choose three kinds
material, MMA/TIG/MIG.
12. MIG torch Connect.
13. Output positive: in TIG mode, this polarity must connect the work piece
14. Gas output joint
15. TIG torch control connector.
16. Output negative ： in MIG mode, this polarity must connect the work piece
17. Power switch
18. Power cable connect
19. Gas input joint
20. FAN
12
SWEISSWELD.COM
Publicidad
