Samsung DV52J8060E Manual Del Usuario página 50

Troubleshooting
Problem
Dries unevenly.
Has odours.
Lint on clothes.
Items still wrinkled
after Wrinkle Prevent
(Wrinkle-Care, Wrinkle
Release).
Water drips from
the nozzle when
SteamCare starts.
50 English
DV8000J-03170M-01_EN-US_150122.indd 50
• Seams, pockets, and other similarly heavy areas may not
be completely dry when the rest of the load has reached
the selected dryness level. This is normal. You can choose
a higher dryness level or a cycle that involves such a high
dryness level.
• If one heavy item is dried with a light weighing load, such as
one towel with sheets, it is possible that the heavy item will
not be completely dry when the rest of the load has reached
the selected dryness level.
• For best drying results, sort heavy items from lightweight
items.
• Household odours from paint, varnish, strong cleaners, etc.
may enter the dryer with the surrounding room air. This is
normal as the dryer draws the air from the room, heats it,
pulls it through the tumbler, and exhausts it outside.
• When these odours linger in the air, completely ventilate the
room before using the dryer.
• Use a cycle featuring the Refresh function. If odours persist,
wash and dry the item again.
• Make sure the case filter is cleaned before every load. For
clothes that naturally build up lint, clean the filter case during
the cycle.
• Some fabrics are lint producers (for example, a fuzzy white
cotton towel) and they must be dried separately from clothes
that are lint trappers (for example, a pair of black linen pants).
• Divide larger loads into smaller loads for drying.
• Check pockets thoroughly before drying, then dry clothes.
Remove lint inside the drum before drying.
• Small loads of 1 to 4 items work best.
• Load fewer items. Load similar-type items.
• Take out the items immediately after drying is complete.
• This is steam condensation. The dripping water will stop after
a short time.
Action
2015/1/23 16:30:05