SICK GTB6L Instrucciones De Uso página 8

OPERATING INSTRUCTION
4 Mounting
en
5 Electrical installation
8 O P E R A T I N G I N S T R U C T I O N | GTB6L
Yellow LED: status of received light beam
2
Green LED: Supply voltage active
3
GTB6L-xxx3x
Sensor which it is not possible to set: The sensor is adjusted and ready for operation.
3
2 3
Mount the sensor using a suitable mounting bracket (see the SICK range of accesso‐
ries).
Note the preferred orientation of the sensor relative to the direction of object motion,
refer to figure 3.
Figure 3: Sensor orientation relative to object direction
The sensors must be connected in a voltage-free state (U
tion must be observed depending on the connection type:
– Plug connection: pin assignment
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanation of connection terminology:
BN = Brown
WH = White
2
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
V
8025391.1K3A/2023/07/04 | SICK
Subject to change without notice